SameDay Heating & Air, Plumbing and Electrical

Installed a new 50-gallon water heater with full code compliance, including new gas line with shut-off valve and flexible connector, new water connections with shut-off valves and flex lines, thermal expansion tank pressurized to match system requirements, earthquake safety straps, drain pan with proper drainage, and updated venting system with draft hood adapter. Obtained all required permits and inspections from local jurisdiction to ensure installation meets current plumbing and safety codes.

Responded to no hot water call at recently purchased property with 15-year-old tanked water heater in basement. Upon arrival, confirmed pilot light was extinguished and ignitor failed to activate despite gas supply being turned on. Performed diagnostic inspection of gas control valve, thermocouple, and ignition system components. Assessed overall condition of aging unit, noting accumulated dust and wear consistent with 15 years of operation. Evaluated gas line connectivity, pressure, and proper ventilation requirements for safe operation. Documented equipment condition through photographic evidence showing mechanical installation and ductwork configuration in confined space environment.

Responded to emergency call for leaking tanked water heater in basement causing flooding approximately one inch deep. Upon arrival, confirmed main water supply to entire home had been manually shut down to prevent further water damage. Inspected 7-10 year old water heater unit and identified active leak source. Assessed pressure reducing valve, associated brass fittings, and copper and PVC supply line connections throughout the plumbing system. Evaluated water pressure gauge assembly and shut-off valve at exterior main water supply entry point. Documented existing plumbing infrastructure conditions including valve operations and connection integrity. Provided assessment of water heater system failure and recommended repair or replacement options based on unit age and extent of damage.